• Applicable for:  ST70+
  • Software Version: v1.08
  • Release Date: October 2010
  • Replaces: v1.06, v1.04
  •  
  • Important Notes: 4 software files are required; (Instrument App, Pilot App & Bootloader together with the relevant autorun file for the MFD you are using. Bootloader must be installed first, then the Pilot App and Instrument App after.

Downloading the Software


Select the software update below depending on which Multifunction Display you will be using to perform the Remote Update. Please note if you have a G Series or a/c/e/gS Series you must check what version of software you have installed in the unit that you are using to perform the upgrade. For further information on this please click here.


A Series C Series Classic E Series Classic C Series Wide E Series Wide G Series a/c/e/gS Series
A Series
DOWNLOAD
C Classic
NOT AVAILABLE
E Classic
DOWNLOAD
C Wide
DOWNLOAD
E Wide
DOWNLOAD
G Series
v2 DOWNLOAD
a/c/e/gS Series
v6 DOWNLOAD
          v4 DOWNLOAD v7 DOWNLOAD


View Update Instructions  |  View Latest Manual


 

IMPORTANT TERMS OF DOWNLOADING SOFTWARE

 

This firmware update process is done at your own risk. Before initiating the update process be sure to backup and make copies of all important files

If the firmware process is interrupted your product may not function properly, therefore do not interrupt the process and ensure the unit is on a reliable power supply. Damage caused by incomplete upgrades will not be covered by Raymarine warranty. 

By Downloading the software, you agree to these terms.

 

 

 

 

Instrument Keypad Sail Pilot Keypad Power Pilot Keypad
Version 1.01 Version 1.01 Version 1.01
No Release No Release No Release


 

Software History


Version Release Date Features
v1.08 Oct 2010
  • Stops the display resetting either after a software upgrade or after running for some time.
  • Corrections to the calculation of Ground Wind Direction.
  • Changes to static heading. Now does not default to Magnetic.
  • The SOG Analogue dial now auto scales correctly.
  • Corrects Pilot Display intermittent crashes.
  • Corrects upgrade fails with ST70 Data Pods on bus.
  • Stops the ST70+ Display resetting when an ST70 Display is set to Polish Language.
v1.06 May 2010
  • The display can develop a fault condition that causes the unit to reset. This normally occurs after power cycling the display. 
  • The display can cause the selected units to drop back to default and the display can also lose the Keyboard setup.
  • Datum tables have been updated to remove ambiguous datum’s and to align with ST70 and MFDs.
v1.04 July 2009
  • Initial Release